MotoF3 FC/PDB Kit
The MotoF3 is an integrated flight controller, power distribution board and frame plate for the Warpquad 200/230/270 frames. The board has a 32-bit STM32F3 CPU with 256K of program flash for compatibility with Cleanflight or Betaflight firmware using the MOTOLAB board target. On-board features include 2Mbyte SPI flash memory for blackbox data logging, audio buzzer, and a 4S compatible switching power supply. Interfaces include PPM, SBUS, Spektrum SAT, and two external UART channels (in addition to the third UART dedicated for SBUS/SAT). The built-in DFU USB device is used to avoid conflict with UART interfaces. Four PWM outputs for motors plus two additional PWM signals for servo passthrough are provided.
The MotoF3 greatly simplifies assembly by eliminating the need for a spider-style wiring harness. The LIPO battery and ESCs all connect directly to the board.
Maximum input voltage 4s LiPo
600mAh 3.3v/5v output regulator Warpquad MotoF3 frame kit
bundles also available.
MotoF3 hardware conversion kit is needed when mounting the MotoF3 FC/PDB kit to an existing Warpquad (As per the second product picture).
Original build video: https://www.youtube.com/watch?v=yF_NbwjXNLQ
Please note the bottom side of the MotoF3 contains power. Proper installation is requires such as electrical tape between the MotoF3 and the carbon frame parts. A short-circuit will occur if the solder mask is breached (very easily done without added insulation such as electrical tape).
It is strongly recommend to use the center carbon plate above your MotoF3 FC/PDB (as seen in the second product picture) for maximum structural integrity.
For support and more information please see MotoLab's RCGroups thread: http://www.rcgroups.com/forums/showpost.php?p=28508139&postcount=3